/s to run scripts that automate
disk-related tasks, such as creating volumes or converting disks to
dynamic disks. Scripting these tasks is useful if you deploy Windows by
using unattended Setup or the Sysprep tool, which do not support
creating volumes other than the boot volume.
To create a Diskpart script, create a text file that contains the Diskpart commands that you want to run, with one command per line, and no empty lines. You can start a line with
remto make the line a comment.
for example, here s a script that wipes a disk and then creates a 300 MB partition for the Windows recovery Environment:
select disk 0 clean convert gpt create partition primary size=300 format quick fs=ntfs label="Windows RE tools" assign letter="T"
To run a DiskPart script, at the command prompt, type the following command, where scriptname is the name of the text file that contains your script.
diskpart /s scriptname.txt
To redirect DiskPart's scripting output to a file, type the following command, where logfile is the name of the text file where DiskPart writes its output.
diskpart /s scriptname.txt > logfile.txt
When using the DiskPart
command as a part of a script, we recommend that you complete all of
the DiskPart operations together as part of a single DiskPart script.
You can run consecutive DiskPart scripts, but you must allow at least 15
seconds between each script for a complete shutdown of the previous
execution before running the DiskPart command again in
successive scripts. Otherwise, the successive scripts might fail. You
can add a pause between consecutive DiskPart scripts by adding the
timeout /t 15 command to your batch file along with your DiskPart scripts.
When DiskPart starts, the DiskPart version and computer name display at the command prompt. By default, if DiskPart encounters an error while attempting to perform a scripted task, DiskPart stops processing the script and displays an error code (unless you specified the noerr parameter). However, DiskPart always returns errors when it encounters syntax errors, regardless of whether you used the noerr parameter. The noerr parameter enables you to perform useful tasks such as using a single script to delete all partitions on all disks regardless of the total number of disks.
انتشار در واتساپ*****
انتشار در تلگرام